manta network bridge

I had the same issue with Omnichain after bridging. Changing back to the original network helped.

Did anyone need to manually add a token before using Fermi Swap with MetaMask? My balance only appeared after I added the token.

For a first DEX trade, Fermi Swap offers a fairly clear starting point. I would test with a modest amount, then review each confirmation.

The best tip I can share is to check the network before asking how to connect Fermi Swap, because the wallet may request a switch.

Fermi Swap liquidity pools showed a different share estimate after I changed the deposit amount, so I checked again.

The route showed low slippage, and the final amount was near the estimate.

The refund steps were easy to locate, which saved me from searching through menus.

The interface matters to me as much as the fee. Bungee is easy to follow, while some alternatives hide details.

The pool position appeared in my wallet after approval, although I gave it time for the network to confirm.

BlackHoleSwap worked smoothly for my last swap. I only raised slippage a little because the pair was thin.